hi

in my configuration the port used is 51770

why? the program tries all those other ports that i doesn't configure?

here config  https://i.imgur.com/B5MEa4N.png

also shows  "partial connectivity only" . . . .

event log

[03:22:00]  New location set: ip:1128
[03:46:53]  New location set: ip:1028
[04:08:15]  New location set: ip:1028
[04:18:04]  New location set: ip:1032
[05:01:28]  New location set: ip:1030
[05:05:32]  New location set: ip:1128
[05:18:12]  New location set: ip:1031
[06:05:29]  New location set: ip:51770
[06:23:11]  New location set: ip:51770
[07:04:30]  New location set: ip:1028
[07:23:13]  New location set: ip:51770
[07:25:30]  New location set: ip:1130
[07:57:39]  New location set: ip:1031
[08:01:57]  New location set: ip:1128
[08:02:49]  New location set: ip:1034
[08:24:11]  New location set: ip:1028
[08:24:38]  New location set: ip:1034
[08:26:27]  New location set: ip:1034
[08:31:58]  New location set: ip:1028
[08:33:33]  New location set: ip:1033
[08:47:12]  New location set: ip:51770
[08:52:38]  New location set: ip:51770
[08:54:42]  New location set: ip:1028
[09:03:05]  New location set: ip:1034


Hi Guest, the program uses the port specified in the settings as a sort of listening port, you change it to something else if you wish between 1025 - 65535, no point in going any lower : )

As people contact you the program will allocate new extra ports for each contact but the base port you have set is the one they will all respond to you on.

I normally set my port to change at random intervals, and have upnp allowed so i dont have to change the router settings manually each time that happens, this helps to prevent ISP throttling.

I hope this is helpful.